Help identifying 3rd member

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 9, 2017
Threads
113
Messages
949
Location
Denver, NC
Hi All -

Bit of a noob question here... I'm trying to buy a rebuildable rear 3rd for my '97 which I plan to ARB. I found one of interest and the guy sent these pics. I need to know 1) if it will fit and 2) if it's e-locked or no?

Thanks!

30629001538_625da46508_b.jpg


30629002538_a9d848fb24_b.jpg


42689991550_3aec9c3147_b.jpg


42689992110_fc74bd2edf_b.jpg
 
no not e-locked are you looking for front (8") or rear (9.5")
a side shot would be the best picture.
that kind of looks like a 8" housing to me.

here is a good source for info
Erik's Toyota Differential info
 
Last edited:
Definitely not an e-locker. That sure looks like a mini-truck 8" V6 rear diff to me. The photos kinda suck. One way to tell is to look at the bolts holding the ring gear, a Cruiser diff is 12 bolts and they pass thru the flange of the ring, with nuts on the back side of the carrier. A mini-truck diff has 10 bolts that go into threaded holes in the ring gear.
 
That is not a USA spec '80 series rear third. The unlocked one has a one piece window carrier and 2 pinion.
 
I bet that's a 100 third. Count the ring gear and pinion teeth and divide to figure out the ratio. The best thing to do is count the splines in the side gears but that might be tricky without taking it apart. 100 series have 32 splines.
 
Thanks to all!!!

Per seller: Ring has 43 teeth and pinion has 10. Has been regeared. Regear parts box suggests it's an 80 set. I will get a pic of the carrier side to verify bolts. Here's a pick of the install box...

29575533747_9cdb1b103c_b.jpg
 
The e-locker diff does use side shims, not adjusters like in those photos. So something is not adding up here...
 
The e-locker diff does use side shims, not adjusters like in those photos. So something is not adding up here...

The non-locker diff uses adjusters. But, they are one piece, two pinion carrier, that is a two piece, four pinion carrier, most likely out of a '100 series. Probably could be made to work, but the correct diff is not rare, should be inexpensive, so....

The other clue; it's geared 4.30, common for the 100 series, don't recall ever seeing that available for the high pinion '80 series?
 
Yeah. That’s a 100 diff. 4.3:1 is 100 ratio. You would need custom axle shafts for it to work and I think the driveshaft flange is different.
 
Thanks to all - case closed - I will pursue other options.

Anybody care to hazard a guess as to what I should pay for a rebuildable 3rd?

Thanks!!!
 
Back
Top Bottom