head crack / crack head experts

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 3, 2005
Threads
370
Messages
4,889
Location
Bay Area
Machine shop found a hairline crack at #3 - looks like it only goes one to 2 threads and rhen stops.

Wondering what anyone thinks if :

Head passes pressure test--should i weld it ? Just run it ? Jbweld? Toss head in trash?

F4017CB9-5162-449C-B12E-4CAF99B73634.webp
 
The p.o. threw $6000 at a new shortblock about 100k miles ago.... 30min with a rag and some brakeclean yielded this with absolutely no carbon baked onto pistons... just some dusty goo from pvc/intake. Mirror shine on the cylinder walls.

9D25374F-3A74-4506-ABB5-E28C47FBBC93.webp
 
Machine shop thought it was pretty small enuff that i should have the head pressure tested first. He didnt think it would be large enough to have gotten into the water jacket

Id be tempted to grind the crack a touch to see how deep it goes and drill both ends....then weld up as mentioned.
 
If it was mine, I would dump it and find a different one and go through it.

Cracked heads are rarely fixable for the long term.

Do it right, do it once.

Why do you have it torn apart?
 
i picked up an uber clean 80 which is getting an om606/h55f --- the 1fz is basically a bonus bottom end that i thought would find a good home in a 40 of mine. Head didnt end up passing a leakdown and i pulled it apart to investigate.

Found this

BAC00E7D-F9BA-411A-B1A2-BA7D48899A10.webp


4B8384C7-9F2C-44E0-B259-57C68C60FAFD.webp


21F84404-8275-4574-9623-6A46F25D3C5C.webp
 
Last edited:
The machinist thinks the head may have been gone thru by Toyota when they did the new short block. tomorrow will be a pressure test and the decide what to do.

The inital plan was to swap this into my 40 - but if the head is trash i need to come up with a plan B.
 
Last edited:
Back
Top Bottom