Harmonic Balancer replacement

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 18, 2006
Threads
137
Messages
992
Location
hillbilly desert rat
My truck was in the shop for another reason and the guy told me that I needed to replace it. he is a very knowledgeable old school 4x4 mech...

My truck has 192k on the clock.... Is there a way to check what he is saying? I am sure it will be a PITA to replace... Getting them off to do an engine rebuild is a real PITA.

any suggestions?
 
Maybe ask what's broken?

Our crank pulleys are made with two pieces of metal and a piece of rubber that's bonded between them. They can separate over time.
 
I would get a second opinion. Not that your mechanic doesn't know what he is talking about, but it kind of surprises me that it needs to be replaced. Like 86tuning said it could have separated, but I take a closer look.
 
What problem is the truck having that makes the mechanic think you have a bad crank pulley/dampner?
 
Can you get a video/audio file of the noise and post it up on you_tube then post the link here??
 
I'm having to replace mine after it separated and shot the front pulley through the fan...

Question, to undo the bolt is it turned anti-clockwise? Just making sure ;-)
 
I'm having to replace mine after it separated and shot the front pulley through the fan...

Question, to undo the bolt is it turned anti-clockwise? Just making sure ;)

Yes, lefty loosey. Pretty easy to do. I left my radiator in when I did the job. Sometimes the “pulley puller” tools are pretty big and it won’t clear your rad, but you can flip the tool around use it backwards. That’s how I avoided removing my rad, otherwise I wouldn’t have had enough space for the tool to work. Hardest part is finding a 300+ ft lbs tq wrench.
 
Yes, lefty loosey. Pretty easy to do. I left my radiator in when I did the job. Sometimes the “pulley puller” tools are pretty big and it won’t clear your rad, but you can flip the tool around use it backwards. That’s how I avoided removing my rad, otherwise I wouldn’t have had enough space for the tool to work. Hardest part is finding a 300+ ft lbs tq wrench.

Cheers, looks like an enjoyable afternoon of cursing on the way.
 
It's really an easy quick job ... if you have the tools for it. 1 big bad 30mm nut.
It would take as much time to loosen/tighten the belts before and after.
You need:
- 30mm x 3/4" socket.
- 3/4" breaker bar.
Lash it under the frame and bump starter to break it loose. (disable ignition - or prepare for way too much excitement.)
Search on this for more info. Maybe youtube video? It's actually quite easy.
- 3/4" x 304ft-lb torque wrench to re-tighten.
A) Find one to rent - good luck.
B) Fake it.
C) A Low Cost 300 ft-lb Torque Wrench - DIY Shop-Built

I don't recall needing a puller, I think it was just very snug slip fit?
Search on oil pump cover seal replacement and front main seal replacement.
 
Last edited:
Back
Top Bottom