hard starting the 80

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 11, 2004
Threads
173
Messages
1,774
Location
tunica, ms
my friends 94 80 takes way too long to start in the morning. it's been about 30 degrees here, but it takes more than a solid minute of turning over before starting. even at this temp that's way too long. we have no idea where to start. i was thinking maybe the cold start injector, but does it even have one?
 
Could be clogged PCV valve, fuel filter, Spark Plugs, Wires, Dist Cap, Rotor, or cracked hose. Has he checked to see if the air filter is clogged.

Most of the above are fairly cheap and you should try one thing at a time so you can see if one makes a difference.
 
i was thinking maybe the cold start injector, but does it even have one?

No cold start injector on the 1FZ-FE.

Sounds like the Fuel Pump Relay. You can test by giving it full throttle when starting. If it starts, then replace or clean the FP Relay. Landtank has cleaning instructions if you do a SEARCH.

-B-
 
Last edited:
I think his write-up is duped or linked in the mergency start procedures write-up in the maintenance section of the FAQ
 
IAC valve?

-B-
 
Those RPMs are ok. I was thinking that the IAC wasn't working and once started it idled around 600 which would be wrong.

I'd next confirm it's a fuel problem. I'd get some quick start and on the next first start of the day, remove the intake hose and give it a spray inside and then reconnect the hose. If it fires right up at least you know it's fuel and can then go on from there.
 
Back
Top Bottom