Hard Brake Pedal...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 8, 2003
Threads
372
Messages
6,846
Location
Bozeman, MT
Well, drove around 150 miles in the cruiser today, with a short run up into the mountains, coming down I had to hit my brakes a bit to allow a faster vehicle by, when I did my truck darted side to side... this was new.

After driving streets (not in the mountains) for another hour and half my brake pedal was getting a bit stiff but still slowing me down.

By the time I got home today, I was needing to downshift to scrub speed and the pedal was stiff as a board.

I am thinking it has to be in the booster? Fluid is good, pads are good, these are disks.

What do I start to look for with the booster?

Thanks-

Rezarf <><
 
SOR has some tests on their web site. I would check the line going from the manifold to the booster carefully and be sure it is not broken or leaking first.

You might also want to check the check valve which is what the vacuum hose attaches to....be sure it is still functional..

Cheers!
 
1Fine40 said:
SOR has some tests on their web site.

Anyone know where this might be? I looked and looked and didn't see anything.

Thanks

Rezarf <><
 
That helps, thanks! Yeah, I had a crazy idle all of a sudden, I guess that is a sign of things comming!

Rezarf <><
 
Just to give yourself that extra confidence, take a hand vacuum pump to the booster and watch that pressure slowly dissapear. That or you are lucky and a line is leaking. On your search for a new booster, remember most toyota brake boosters will bolt up, giving you an opportunity to update parts.
 
Well, I just picked up a booster from a mid 80's mini truck at the local yard. However, in my haste I did not pick up the check valve, I am assuming it is remotely located per another post.

Would a store like NAPA carry this kind of part? Or should I head down to the dealer?

Thanks again.

Rezarf <><
 
REZARF, I know you picked up one of those check valves, does anybody have a picture or description of this part? And while I'm at it, the minitruck booster I got is about 3-4" shorter than the OEM booster. So what happens with the brake lines when the new booster is installed? They're steel right? So I don't imagine they would want to move the 3-4" closer to the firewall so they can still mount to the master cylinder...:confused:
 
The lines if OEM will have coils or loops of excess line that allow for movement of the cab in relation to the frame. These coils will allow the lines to move that far easily. On the other hand if they have been replaced and the coils were not put in then you may need to make new ones.
 
subzali said:
REZARF, I know you picked up one of those check valves, does anybody have a picture or description of this part? And while I'm at it, the minitruck booster I got is about 3-4" shorter than the OEM booster. So what happens with the brake lines when the new booster is installed? They're steel right? So I don't imagine they would want to move the 3-4" closer to the firewall so they can still mount to the master cylinder...:confused:


The check valve is a small plastic piece, whiteish in color, it is on large vacuum line between the engine and booster. It is roughly 1.5" long and an inch around.

Hope it helps.

Rezarf <><
 
as I just went through a similar problem recently, THAT thread may be of help?

I'm a little worried by the "darted side to side" thing though? what the heck would cause that?!? I wouldn't think a bad booster would.... :confused:
 
Back
Top Bottom