Fuel level sender problems?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 19, 2003
Threads
450
Messages
3,150
Location
38.0111,-109.9181
Website
www.alamosa.fm
This week I'm gonna crawl under and start checking continuity on all wires, but my fuel level guage just seemed to go `dead' resently, looks like there is either a short or a disconnect somewhere. Before I start pulling my hair out testing everything and running random wires back and forth, is there a common fail point where I should first start checking?
 
The wires right at the sender have been the source of insturment issues for me in the past...

If you do not see anything obvious there....remove the sender and ohm it out....


Still nothing, disconnect the battery from the truck, remove the instrument cluster and ohm the wires to the cluster for the fuel circuit and test the gauge.


Good luck!


-Steve
 
The sender needs a good ground. You can always jumper one to some good metal.
 
FWIW, I tried and tried and tried to fix my stock system and ended up putting in 2 after market sending units on 1 gauge (as I have 2 tanks). Point is, JC Whitney has a nice sending unit and gague if you need it that works perfect. Search this Tech section as there are several threads on it.

Ideally, I wanted to keep my in dash setup as anyone would, but I just could not find the issue (even after all kinds of posting you can find here and taking out dash and sending unit and hooking it up outside of the rig, etc) so I just rewired in a new one as I was confounded... and ended up being able to add a second tank to that 1 gauge... bonus

BTW, both CCOT and SOR sell sending units if you confirm it is just your sending unti that is dead. Heck, they even sell gaugaes if the gauge is the proven issue.
 
I agree with Poser, usually the problem is with the little clip-on connection at the sender. I've tried bending it a little with some small needlenose pliers. That usually fixes it for 6 mos.
GL

Ed
 
Buff up the contacts with a miniature file.
 
Back
Top Bottom