Front Sway Bar Mounts

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 5, 2003
Threads
110
Messages
1,847
Location
Sacramento, California
Website
www.instagram.com
While I was starting to climb up Cadillac Hill, my right front sway bar mount broke. And as the sway bar end moved from it's stationary position, it tore off a piece of brake line. In seconds I knew I was in trouble.
Thankfully, Robbie Antonson was there and best of all, Cruiserdrew had a spare. Between the two, I was back on the road in no time. The brakes were working again, but there was no front sway bar.
I need to add to this story, that a few months back, I'd removed the rear sway bar. So I had no sway bars on La Cabra. Driving around like this on a lifted truck is not a good idea. I don't want to think what would happen if I had to make a sharp maneuver on the freeway.
Anyway, yesterday Crewserdew came up with a clever solution on the front sway bar mounts. Here are some pics.

_MG_2586.jpg


Regards

Alvaro
 
Last edited:
I just removed my front sway...leaving the rear in since that seems to be where the bulk of my on road sway is in panic steering.
 
I did it purely to prevent the exact problem many have had with the sway breaking loose and taking out the hard line. When I removed mine I found the bolts were both bent and about to let go. I suspect the failures mentioned here have to do with the bolts failing. I don't think the brackets are failing, so if you wanted to keep the sway you could always upgrade the hardware?
 
Dan,

In my case both sides failed. The first to go was the left side about 2 years ago. Then more recently the right side.
Both times it was the factory weld on the bracket that gave in. Not the bolt.

Regards

Alvaro
 
Ken,

Tight fit. No play.
The steel was 2 inch by 3/16 thick.

Alvaro


Nice job !

How is the fit on that hitch pin? any play? is it 5/16?

ken
 
Last edited:
James,

The only warning sign was having too much fun.
If you like to wheel with the sway bars connected, then my recommendation would be to upgrade. If you disconnect the sway bar, then, you've got nothing to worry about.

Regards

Alvaro

PD: Always carry spare break lines with you...
 
Wow - nice work Alvaro and Andy.

Remember the heaviely modded Jeep we had along on the February, 2007 Anza trip that lost his bolts to his sway bars? I followed him into the San Diego area for saftey reasons until he could replace them. It was VERY scary seeing him take all the mountain curves up and through Julian. Every corner looked like he was going to tip, and he was, rightfully so, taking it very easy. I can't imagine what a heavier vehicle like LaCabra would be like w/o sway bars.

Glad you made it out safely and have a good fix!
 
Spring rate and shocks also play a huge roll. If you have rancho adjustables I am sure the body roll wouldnt have been as significant.
Wow - nice work Alvaro and Andy.

Remember the heaviely modded Jeep we had along on the February, 2007 Anza trip that lost his bolts to his sway bars? I followed him into the San Diego area for saftey reasons until he could replace them. It was VERY scary seeing him take all the mountain curves up and through Julian. Every corner looked like he was going to tip, and he was, rightfully so, taking it very easy. I can't imagine what a heavier vehicle like LaCabra would be like w/o sway bars.

Glad you made it out safely and have a good fix!
 
A proper set of shocks with correct valving can compensate somewhat for the lack of sway bars.
 
Back
Top Bottom