Front Passenger Fender Removal??

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 23, 2015
Threads
36
Messages
237
Location
Pampa, Texas
Has anyone ever removed the front fender? How hard is it? I have a pretty good dent that I need to pop out. I think I might could get to it if the inner fender was removed, but it looks just as complicated... any insight?? I didn't find any write up on it here....
 
Not too hard. have to take out headlight and turn to get to the bolts including the front valence bolts, have to take off wiper arms and that cover to get to one bolt. Worst depends on your rust area with the bolts along the wheelwell. Typically I have to grind off a couple as the plastic retainers break, and they spin inside and you cannot get out. I should mention that seam sealer was used over that wheelwell joint area, so you have to cut it out, then the question is if you replace or just leave unsealed, which I do. The two lower bolts can be rusted bad, and hopefully for you not buried under sliders, to the point you have to pull the sliders off first. :(

So, I would say 30 min to 3 hours.
 
Back
Top Bottom