Front Heater Color

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Heater on left is a 1976, right is 1971
The plastic is med/dark grey

IMG_6675.webp

Top left is the 1976, top right heater plastic is a shade darker but I don't know manufacture date
IMG_6676.webp
IMG_6677.webp


1976 with black tape for contrast
IMG_6680.webp


Inside plastic of unknown vintage heater
IMG_6683.webp
 
No but I'm hoping you tell me please. Thanks

The only thing I know about painting plastic is the results can be bad if not done correctly.

So is your plastic faded and scratched up? I have had pretty good luck restoring a few plastic peices by simply wetsanding the top faded/scratched layer off. I usually start with 320 and work my way up to 3000. In some instances I've used the dremel EZ-Lock coarse buffs to remove deep scratches. After 3000 grit I use plastic polish. Definately more work but it's an option.
 
A good soak with some 303 can do wonders, too. Old plastics can get pretty brittle over the years. 303 or something similar can add back some oily goodness and restore the color quite a bit. Might be worth a try before pulling out the big guns.
 
If the other solutions don’t work don’t be afraid to paint - it goes on nicely and I’m totally happy with the results. I used duplicolor vinyl & fabric paint. This is charcoal grey.
8C4144A5-2FB4-4F05-B8A7-611DDC77EFE9.webp
 
Mine is a 1/76 and when comparing the original un-faded colors on the inside of the vent vs the housing it's attached to, the vent is more of a charcoal gray on a black housing. SEM's 15243 Satin Black was a dead ringer for the black, but their 15393 Medium Gray is a little lighter than the original vent color. 15303 Graphite would have been a better match. The durability and finish of the SEM is very impressive.

I plan to have the metal powdercoated gloss black.
 
Back
Top Bottom