Front end not even

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 13, 2017
Threads
13
Messages
98
Location
Van
My driver side is lower than passengers side by 1/2".all stock except new tie rod and shock.
Measure from center of hub to fender flair
Is 19.75" vs 19.25" and my caster is off alignment on driver side by 4.3 to 4.7 degree reading. What to look for to obtain proper remedy
Thanks
 
I would just go wheel the snot out of it and then remeasure. Neither one of those variences are worth worrying about. It is likely to change small amounts with use. Less than 1/2 of a degree is still in spec, IIRC. not even noticable in steering feel or tire wear.
 
Side to side caster is generally set slightly different due to the rounded nature of road construction. Of the three axles I've done cut and turns on, there is always a variance of .2-.5 of a degree side to side.
 
From my research a 1/2 inch difference in spring height from front to rear, or side to side is pretty common.

Oh one more thing, after you take it out and wheel it hard like Inkpot told you to do, don't be surprised if that height difference changes.
 
My rear was off by 1.25" with the passenger side being higher. I put a 30mm spacer in the driver's side and it still off but it's much less noticeable.
 
Back
Top Bottom