Front and rear axle work

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 25, 2007
Threads
60
Messages
2,750
I've had my truck for about a month now and I'm starting to get comfortable with the idea of tearing bits of it apart. The truck is at 140k miles and I don't have any service records. I'm now looking at doing my front axle seals because my diff fluid is full of grease, and the outside of my knuckles look like the long lost sister of Miescha's truck. I have read Romer's awesome write up in the FAQ, but I still have a few questions going in to this:

1 - I have Beowulf's excellent Excel spreadsheet for the front axle. Is it worth replacing the steering knuckle bearings at this mileage/unknown history? What about the hub/wheel bearings? I have no idea of the lifespan of these parts.

2 - If I take out the steering knuckle bearings can I re-use the preload shim? If not, how hard is it to adjust the bearing preload?

3 - I do have the FSM and it talks about a bunch of different special service tools. How many of these do I actually need (other than the 54mm socket)?

I've learned so much about these awesome trucks so far and I'm looking forward to getting deeper into mine! :cheers:
 
1 - easiest way to decide this is 'will you still own the truck at 190,000 miles? If yes, then replace them because somewhere in the 170,000 mile range you'll be thinking "Crap, why didn't I replace them back then"

2 - Yes, you reuse the factory shim. It was shimmed based upon using new factory knuckle bearings and races.

3 - You'll need a seal puller or can make one as some thread searches will reveal. You'll also need a brass drift thin enough and long enough (I think I use 3/8" and about a foot long) to tap out the old steering knucle races. Other than that, read the FAQ here and on another site I cannot recall.

DougM
 
I have the full kit downstairs to do mine this week..plus a new PS knuckle due to a slight injury it sustained :)
 
do it all for the peace of mind and the experience. You will learn alot about your rig....
 
1 - easiest way to decide this is 'will you still own the truck at 190,000 miles?

That's the plan! So I'll get all new bearings and seals today.
Thanks

Since I did mention the rear axle in this thread title, I guess I should ask about it. Should I be doing it at the same time? Is it any harder than the front?
 
For the rear you'll need a SST or other tool to remove the rear lock nuts. Some have used Dana 60 front hub sockets. You can buy the OEM from CDan or make one as others have done.
 
Back
Top Bottom