Fresh Air Vent??

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 25, 2013
Threads
10
Messages
22
Hi, can anyone help me with the cable hook up? My fj40 fresh pull cables were missing and trying to hook them back up to vent. I cant figure out how the end of cable connects to vent. I am not even sure if I have all parts. A pic would be great, I have searched for pics but , they usually show everything except the connection to vent itself. Thanks so much!
 
the cable goes thru the plastic grill, there should be a place on the side of the housing to slide the sheath in place, the loop of the cable goes over a pin on the door.
this was from memory, so I think it's fairly accurate.
 
Cable goes though cage and hooks on to the door.

IMG_1948.webp

IMG_1945.webp


Josh
 
The cable should have a "loop" at the terminus if memory is correct. But, if you have the knob you could get a replacement from McMasterCarr complete with the housing. Guest-a-measure it and go long. You can shorten it if need be.
ok thank you !!
 
1: Alright, so I just tore my blower assembly apart to clean and paint.
I noticed that I have none of the foam stuff left to seal the part. Where can I buy it/what is it.

2: Where can I get the screen/mesh View attachment 1337088 ?'

Thanks!
 
I got all the foam from my local hardware store to reseal the blower vent door and the front heater. Sheet of thin open cell foam and spray glue and a roll of narrow strip adhesive backed open cell foam.
91155D45-83E1-42A5-9754-2D09F558E817.webp
8E8D326F-AECD-4F09-AF56-9371450A62A4.webp
 
what is the cable route? through glove box? i have too much slack with no obvious mounting locations on the 79’
 
Back
Top Bottom