Well nothing in life is truly free, but I made this from parts I already had lying around.
I was looking at the reservoir cap wondering how I could attach a pressure hose... I've seen guys use various plumbing fittings. Noticed that in the middle of the cap there is a smaller rubber cap that pops off, and underneath is a little pin hole breather. Hmmm... will a sports ball inflator needle fit and seal well enough to pressurize the system??? It does!
Then used another thumb valve in-line with air lines long enough, so I can sit at a wheel, crack the bleeder, and let a little pressure into the system, and presto! One-man bleeding. No more grumpy wife... at least not from bleeding brakes!
I was looking at the reservoir cap wondering how I could attach a pressure hose... I've seen guys use various plumbing fittings. Noticed that in the middle of the cap there is a smaller rubber cap that pops off, and underneath is a little pin hole breather. Hmmm... will a sports ball inflator needle fit and seal well enough to pressurize the system??? It does!
Then used another thumb valve in-line with air lines long enough, so I can sit at a wheel, crack the bleeder, and let a little pressure into the system, and presto! One-man bleeding. No more grumpy wife... at least not from bleeding brakes!
