$£¥¢ For Sale / Trade / Wanted
- Thread starter retrofive
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
http://www.fjparts.com/hub-free-wheel-96-up-fzj80-hdj80-hzj80-80-75-series-p-1764.html
Brand new and you don't have to modify your birf..
Brand new and you don't have to modify your birf..
nice
I found a set of my old ones but looking at them I realized why I replaced them.
My 93/94 didn't have the short spline birf, I had to notch it for the circlip, made a spacer to guide a dremel cutting wheel, not that hard just have to go slow.. I don't know if the fj80 has the same birf or not.. There are a bunch of threads on here if you want to waste a couple of hours..
- Joined
- Jan 8, 2006
- Threads
- 265
- Messages
- 9,822
- Location
- Ashland, OR
- Website
- www.jeffersonstatecruisers.com
Looking for a piece of metal for the roof of Green Bastard... Preferably a piece out of the roof of a truck or car with slight convex shape to it. I want to cover up my new plywood sunroof so I dont' have to worry about the rain soaking into my truck.
I need a piece about 38 by 21. A piece out of a large door might work... Who's scrapping a car or truck????
I need a piece about 38 by 21. A piece out of a large door might work... Who's scrapping a car or truck????
- Thread starter
- #1,068
I honestly think you are going the wrong way with this. I think it should have a bubble dome on it.Looking for a piece of metal for the roof of Green Bastard... Preferably a piece out of the roof of a truck or car with slight convex shape to it. I want to cover up my new plywood sunroof so I dont' have to worry about the rain soaking into my truck.
I need a piece about 38 by 21. A piece out of a large door might work... Who's scrapping a car or truck????
We have the lid to a huge tamale pot! You can use the handle for a tow point.
It is blue however.
It is blue however.
- Joined
- Jan 8, 2006
- Threads
- 265
- Messages
- 9,822
- Location
- Ashland, OR
- Website
- www.jeffersonstatecruisers.com
Poor Jesse! No more room over there!!
- Joined
- Jan 8, 2006
- Threads
- 265
- Messages
- 9,822
- Location
- Ashland, OR
- Website
- www.jeffersonstatecruisers.com
Nah, I need the bubble dome for the floor..... So I can see what's detaining me..... 
Trying this again... I need a GM truck bellhousing. I would prefer the cast steel one (cast number 3925505) but will be happy with an aluminum one as well (cast numbers 460486 or 6263756). Easiest way to tell if it is for a truck is the center hole is 5" or 5.125" and it is set up for a mechanical clutch linkage (not hydro). Please let me know if you have one you are willing to sell!
Swagmobile! Wonder what's a reasonable offer?? Have Jesse go get it. 
You know.......raffle booty...! Or I could steal the "swag" lamps when I'm at my Mom's! 
http://medford.craigslist.org/pts/4865611035.html
are these just OEM?
are these just OEM?
Quick googling on the spring number says they are stockers.
Apparently I was just fat fingering it because I tried that and found nothing, then just did it again and they popped up