Great build, brake and repair thread. Good to see the Hundy gets used on the trails. Did you notice a big difference in stability when wheeling with the rooftop tent? How do you like the part-time kit?
Build FLEXUS 2000 LX-470
- Thread starter jrmudder92
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Fun build thread. Totally missed it before now.
I think my dad may have followed behind you at a club event back in the Spring. I kept getting pictures of the "Flexus" from inside his green TJ. Between your truck and a JDM turbo diesel 80, he wants a Cruiser now
I think my dad may have followed behind you at a club event back in the Spring. I kept getting pictures of the "Flexus" from inside his green TJ. Between your truck and a JDM turbo diesel 80, he wants a Cruiser now
I love the lighting upgrade in the engine compartment!
- Thread starter
- #104
Umm nah. It a bit more top heavy. But nothing has stopped me yet. Just have to be careful not to bash it on walls or what it haha. Pick your lines good. I loveeee the part time kit. I can do burn outs now haha. Honestly the only reason I did it was for torque steer. That has completely went way. And it’s super nice to have a 2 wheel drive low. On the trials. I would def recommended it.
- Thread starter
- #105
Yeppp. I remember that hahaha. They are great vehiclesFun build thread. Totally missed it before now.
I think my dad may have followed behind you at a club event back in the Spring. I kept getting pictures of the "Flexus" from inside his green TJ. Between your truck and a JDM turbo diesel 80, he wants a Cruiser now
- Thread starter
- #106
Thanks well worth it for sure.
LED Engine Compartment Light KIT - Hood Light Kit for Toyota Land Cruiser 100 Series Lexus LX470
yodaTEQ Engine Compartment Lighting (ECL) KIT is designed and built for the Toyota Land Cruiser 100 Series UZJ100 & Lexus LX470 Video Installation Instructions Written Installation Instructions For overland, expedition, offroad, dual battery, tire inflation setups, etc. When night time...
yodateq.com
- Thread starter
- #107
Had it buffed and detailed.
- Thread starter
- #108
Cliff notes on what’s new!!
So from where I last left off there was nothing “new” to report with the cruiser. Added a solar panel on top that’s about all. Then I went out a bought a 2019 stinger GTS. Have add lot to this so far haha. The stinger has basically gotten all the attention while the cruiser has been sitting.
I would still drive the cruiser ever now and then. But I have been getting check engine light for “misfire #1” put new coil, plug, fuel injector. Still get it. Did a compression check and leak down. And basically #1 cylinder is gone.... sooooo. Had been deciding on used or reman or rebuild. So I bit the bullet and did a reman one from aaa engine.
So from where I last left off there was nothing “new” to report with the cruiser. Added a solar panel on top that’s about all. Then I went out a bought a 2019 stinger GTS. Have add lot to this so far haha. The stinger has basically gotten all the attention while the cruiser has been sitting.
I would still drive the cruiser ever now and then. But I have been getting check engine light for “misfire #1” put new coil, plug, fuel injector. Still get it. Did a compression check and leak down. And basically #1 cylinder is gone.... sooooo. Had been deciding on used or reman or rebuild. So I bit the bullet and did a reman one from aaa engine.
- Thread starter
- #109
More pictures of motor swap. Swapping all the parts over from the old to the new. All new hoes should be here tomorrow
- Thread starter
- #110
Also got some DT headers. They are very nice. Have run into some issues with them tho. First being. They only sent half the hardware for them. Second being the o2 bungs are completely in the wrong place from the factory headers. So we plugged the holes with bung nuts. Will weld them in to the pipes. As you can see if left in there the passenger side would o2 never be able to be replaced with out lots of work.
- Thread starter
- #111
More random pictures. Had to grind the oil pan a bit for the oil pump plug. Disassembled and cleaned the intake.
- Thread starter
- #112
That’s all for now. Hopefully have it running tomorrow and new exhaust by Friday.
- Thread starter
- #113
Unfortunately didn’t make too much head way. We got it In and bolted up. That’s all.
- Thread starter
- #114
Well she run. It’s open header. Stilling at the shop for a complete exhaust system.
- Thread starter
- #115
Well she’s all done. And on the road. Here’s some exhaust
- Thread starter
- #116
- Thread starter
- #117
Also did a good cleaning of the rear drawers. And put everything back in.
- Thread starter
- #118
So been getting a few messages about any updates on this. And I could have sworn I updated this but obviously I didn't. I sold this back in June it was on BAT. Heres the for sale link SOLD - No Reserve BAT. 2000 Lexus LX470 *Bulit* *3xLocked* *Overland* Then shortly after I bought a 200 series. Builds - 50 shades of gray, 2011 Land Cruiser Bulid So I'm still in the game. Just upgraded a little bit. But I will say this The bigger v8 is very nice. The biggest improvement is the transmission going from a 4 to a 6 speed is amazing. That alone was worth it. My only real complaint is no one has made a part-time kit for this yet. I do miss my 100 had a lot of fun and great memories in it hold's a certain place in my heart but on to a newer one. Sold it to a couple in Texas. They flew out here and drove it home. Anywho sorry I never updated this. But thank you 100 series forum for all the help! The pictures are from when we got it ready for selling some of the last ones I have of it.
