Fj80 Massive Hesistation

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 16, 2013
Threads
4
Messages
50
1993 FJ80, new to us truck. It had a code for both knock sensors, and both o2 sensors. It now has two new o2 and two new OEM knocks. That cleared the CEL we had. We also have a big hesistation/cutting out issue. At operating temp only, it is quiet happy to cruise around under light throttle, but anything more than say 20% throttle and it starts cutting out and bucking. Feels almost like an ignition cut. Ran a similar AFM for a different car on it with the same plug and throttle size. I assume differnet values too so wasn't expecting it to run correctly, just to see if it changed the hesitation. Hesistation totally gone. Replaced the AFM with a new rebuilt unit, hesistation still there. CEL lights up when it cuts out and bucks, but it extinguishes after a few seconds after you let off the throttle. Fuel pressure good, runs fine cold. Just passed smog fine too. Going to explore the EFI relay, fusible link and egr wire loom tomorrow. Any outside ideas for me as well. Thanks.
 
I'm a 1 banana YouTube watching mechanic but hesitation under throttle sounds like fuel delivery to me. Id look at injectors first and a new filter. Also look at the air intake...do the free stuff like clean the throttle body and IAC.
 
Sounds electrical. Bad ground perhaps.

You need to follow the FSM outlined troubleshooting procedures on this one or you could be chasing it for a long long time.
 
Back
Top Bottom