For Sale FJ40 shorty running boards- SoCal

[65swb45]

Location

United States

Got these with a parts rig a long time ago, put them on a high shelf, and promptly forgot about them. IIRC, they started out from stock 1971 boards. $130’plus the ride from Burbank. No PMs please.

 

[65swb45]

Comments?

 

[65swb45]

Ttt

 

[rkymtnflyfisher]

Comments?

Kind of cute

 

[65swb45]

@MadMace

 

[MadMace]

Thanks Mark. If you can get those on diet to thin them up a little, they‘d be perfect.
Not quite the ones I’m looking for, I appreciate the tag so I could check them out.

 

[65swb45]

Still have these.

 

[bmoonhajjar]

Dimensions? Any rear support or just diamond plate? Any edge trim on them? Hard to tell from photos.

 

[65swb45]

Dimensions? Any rear support or just diamond plate? Any edge trim on them? Hard to tell from photos.

Good points Brian! Thank you. I will make a note to get that information tomorrow.

 

[65swb45]

Edge is fully formed. Inside edge has two factory rocker panel holes. Since the step is now shorter AND centered over the stay, I would say it supports weight better than the original, in which most of the running board just hangs off the rocker.

In hindsight, I realize this was/is very important information to have on a part that has been modified. Thanks again @bmoonhajjar for bringing it up.

 

[65swb45]

Ttt

 

[65swb45]

+