FJ40 Antenna

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

@WaTrout88 do you still need a pic? Sorry been crazy at work.
 
Yeah that would be great. After further research on using wireless antenna or a CB antenna. I think I am just going bite the bullet and use a OEM one.
 
On this 7901- BJ, the antenna is on the left side.

antenna_bj40.webp
 
When I had my body redone we welded up the POs hack job holes for the antenna. Does anyone if there is a system out there with new technology to just go antenna less?
I tried one of those antenna wires you say wrap around the windshield rubber, slip the wire out of sight . Reception was very poor.
 
Does someone have exact measurements of the antenna mounts/holes like in post #8 and #24? Looks like the antenna is running over the center of the 2 windshieldhinge-bolts? TIA
 
@LandHJ45Cruiser

From my 1973 FJ40:

I replaced the antenna with the same OEM model that was originally installed. Note that the two support screws weren't precisely vertically aligned with the tub flange. I don't think it matters, since I never noticed it until I took these pictures for you.

My understanding is that this area is the preferred location for the antenna, since the LHD driver can reach out the window and raise or lower it to avoid damage from close brush on tight trails.

antenna 1.jpg


The centerline of the upper screw appears to be exactly 32mm from the face of the flange. I used a rule that ended at 152mm (6.0 inches), and the C/L was at the 120mm graduation.
antenna 2.jpg


This shows the rule pressed up against the cowl flange:
antenna 3.jpg


The location of where the lower screw penetrates the cowl. I measured 35mm from the cowl flange on the outside of the cowl (same flange as upper mount.) Note that it's almost on top of the kick vent flange:
antenna 4.jpg


Finally, a final (fuzzy) picture of the lower screw vs. the door hinge bolts. No interference!
antenna 5.jpg
 
Last edited:
Back
Top Bottom