FJ V-8 POWER

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 14, 2009
Threads
13
Messages
207
Location
Hsinchu City, Taiwan
Website
www.facebook.com
Found this...



and this, wonder what year this was... and if somebody really choose the 365 hp motor must have been a blast...

Screen Shot 2018-04-06 at 10.02.12 PM.webp
 
Last edited:
Con-Fer (an aftermarket 4x4 shop) used to take FJ40’s straight off the boat from Japan, yank to F or 2F engine and drop in a Chevy V8. This is an ad for that service. I believe Toyota eventually sued them to stop, but there were a couple of places that did it.

My truck was actually one - it has all the tags, California engine conversion notes, etc. from a company called Go-TEN manufacturing that appears to have done this back in the 70’s as well. I googled their business records before, if I recall they went out of business around 1975/6.
 
Just like Tasca Ford did when they built the 1968 Mustang 428 Cobra Jet. That dealership made Ford tons of $ after they created the R-Code Mustang. Also put Ford on the racing map that year.

That Toyota dealership advertisement is pretty darn cool.
 
If it ain’t a clunky old in line 6, it ain’t a 40.

:-)
 
If it ain’t a clunky old in line 6, it ain’t a 40.

:)
I can't agree with that. In the early 80's I had my 73 40 converted to a junkyard chevy 350 and saginaw powr steering, my god what an improvement in everyday driving and blew my mind in wheeling in mud and hill climbing.
I had driven that truck fot approx. 6 years before the switch and loved every minute with both.
As an old man now the six is nice.
 
I loved my 1.5F... it was a sad day when it died. I might even go so far as to say it was murdered by the PO. However I managed to keep it running for 50k miles despite the damage done by POs.

In ‘96 I couldn’t afford $3k+ to rebuild the F... thus it got a 300hp+ 350. It was never wanting for power... at 95 mph I shut it down because it’s top speed was nowhere to be found. Yet on the flip side it’ll pull below idle in third gear.

When that $300 motor died 21 years later it got another 350. This time a 70k one owner 4-bolt SBC that was so clean inside you could almost eat off it. Now with an RV cam, 4 barrell carb, SP-2P intake, and a walker quiet flow single exhaust the 40 lives again. It’s not the same as a six... but it’s truly a thing of beauty to drive. I feel it’s folowing in the spirit of a 40. It’ll pull at 400 rpm, it is super smooth, quiet, and reliable... and it longs for nothing on the highway or the trail. Unless you look under the hood it’s not obvious it has been modified... and many would mistake it for a 6, even though it fires 4 times per revolution.
 
I know the OP’s intent was not to make this (another) V8 vs F engine thread but...

I’m a purist at heart but even I am ultimately happier with a 350 than the 2F my truck never had. Go-TEN converted the truck in 75/76 as far as I can tell - almost, if not immediately, straight off the boat.

Having driven a couple of F-engine trucks, I agree there is a shift in character when you install a V8. But the improvement in streetabilty, power, etc you gain from a bit more ponies is hard to argue with. The only issue is that it shifts the max torque band up into the 3000rpm range, as opposed to 1800 or so on an F. The 350 still makes good torque in the lower RPMs too - so I don’t imagine it’s a huge loss.

The main reason I dropped another 350 in my truck was really repairability. It’s getting tough to find the parts and shops with knowledge to rebuild a 2F when it dies. 1F’s are next to impossible. A 350? They’re so ubiquitous I’m not sure they’ll ever stop making parts for it.
 
Someday someone will stumble upon the warehouse that has all those pulled f/2f engines sitting in crates. Or did they ship them back to Mr. Toyota? Any idea on how many conversions they did “straight off the boats.” Number should be in some historical business records. Then again...
 
I loved my 2f. But still I did all the fancy stuff ,header , 2 barrel Holley , distributor. , loved it.
But nothing beats driving. My 350 check to and from work to the trails. 4000km round trip to Pismo and back. It would
Of killed me to listen to that 2f all the way down the i5. The 350 just cruised And it still was annoying with high revs Even rolling on 37’s. I know though , it isn’t a 40 if it isn’t stock. I do agree with that. And mine is far from stock but I wouldn’t want it any other way.
 
Back
Top Bottom