Emergency Brake Shoes

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 19, 2007
Threads
18
Messages
36
Location
STerling VA
Hi all,
I have a 96 80 with 145K miles on the clock. I have had this truck for almost two years and now my emergency brake has to be pulled up all the way for the emergency brake to catch. Last week i pulled the rear rotor off and seems like a new set of brake shoes may be in order. My question is has anyone every replaced the rear brake shoes if do you have any pictures of how its done. I normally do all my brakes and minor maintenance but have never done Brake shoes. Any /all help would be great.

Thanks.

Zed Crusier
Go HOKIES
Ut Prosim - That i May Serve.
 
$10 to TIS and you can download the instructions. Only about a 1/2:banana: job.
 
Zed,

Poser replaced the e-brakes plus components for someone here not too long ago. He took pics and posted up a pretty nice "how to" thread. Not sure if this is in the FAQs but it probably should be if it isn't. Anyway, rather than just tell you to search I'll give you a head start. Here is the thread:

https://forum.ih8mud.com/showthread.php?t=135349

Also, looks like your first post so here is the official MUD welcome :flipoff2:

Also, here is the link to the 80 series FAQs which you should probably spend some time reading through as well :) - It is a sticky at the top of the 80s forum

https://forum.ih8mud.com/showthread.php?t=84888
 
If your shoes are worn out you want to start thinking about why that happened. These aren't like regular brake shoes where they are applied to create a controlled stop but rather clamping an already stopped drum.

The most common issue is with the bellcranks. They seize up and cause the shoes to drag on the drum and wear them out. I've dealt with this enough on my 80, 60 and 4Runners that I now just R&R everything and coat it with white Litium which stops the problem from happening again.
 
Fixed my e-brake today, works great now!

Before:
DSC01707.jpg


DSC01710.jpg
 
The most common issue is with the bellcranks.

x2. Mine wouldn't release and were riding the pads. I replaced the bellcranks, springs, pins, pads (didn't need to, just figured I would since I was in there), boots, etc. If your stuff is corroded, it can be a slightly more difficult job cutting/hacking the old stuff out of there.
 
Back
Top Bottom