Electrical Nightmare

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 11, 2006
Threads
78
Messages
797
Location
Dallas, TX
The PO was a body-man and didn't know much about electrical systems (I don't know much myself). I have a Haynes on the way, but also wanted to ask the forum how to approach the electrical system:

- Only the speedo works on the instrument panel, temp did work but crapped out when replacing fuses.

- Loose wires throughout the engine bay, cab.

- I'll be installing a stereo in a Tuffy...any suggestions?

Should I wait for the Haynes and give it a shot or should I try a whole new system?
 
Welcome to to wonderful wolrd of second hand fun! The wireing is really not too bad in an older Cruser. I don't know about the later(after 76) ones. The wireing dia. in the tech section under electrical stuff is nice becouse you can print it out big enough to see. Get a good crimper tool and the right size butt connectors and replace anything that looks funcky. If the fuse box is rusty; replace it. I put in two of the Blusea marine fuse boxes and most of my electrical problems went away. You can buy a complete harness and starte over, I personnelly wouldn't do that unless I was pulling everything apart for retro/paint.
 
What year FJ40?

Just start following the wires. Your guage panel may just be the connection on the back of the cluster. Disconnect the battery. REmove the cluster screws. remove cluster and check the connection on the back. REinstall and reconnect battery.

MAke sure you have a good ground. BAttery to block. Block to frame. Small ground wire to body off of battery. This solves a lot of problems. If the rig has been repainted you may not be getting ground do to the paint in the threads.
 
It is a '79 and it has been repainted. I am leaning towards trying to map it out and go by trial and error. Replacing the fuse box is a good idea...thanks.

I was able to find some good info on stereo/tuffy in the FAQ/Stereo thread.
 
There are two types of problems that are common in older cars, like cruisers. the first is bad or corroded connections. These can be anywhere between the battery and the ground, but chassis grounds are particularly susceptible to corrosion since they are steel, which rusts.

The second type of problem is improper wiring that has been added over the years. This is hard to diagnose, since it is hard to know what it does and where it coes without tracing it from one end to another. Fortunately, this wiring runs outside of the harness and does not typically use the stock Toyota color code. A wiring diagram is your best friend. The first thing to do is to check and clean the main feed system from the battery and alternator through the amp meter to the ignition switch and fuse block. It includes the battery to frame and frame to engine grounds. This is the most important as it feeds everything and runs your ignition. After you have that nailed down, any problems will be localized to a single circuit that starts with a single fuse in the fuse block. Get a test light or a meter or both. The test light is most useful and you can get fooled about the adequacy of a circuit with a meter if you don't have current flowing in it.
 
Since you said that your temp gauge crapped out when replacing the fuses, make sure you clean the fuse connections in the fuse block. That could be part of your problem (along with everything PinHead said).

Good luck!
 
Disconnect the battery and do what is suggested above by several. Clean as many connections as possible with a wire brush. I have had problems with instrument clusters in the past and just cleaning the connects would fix them. The fuse block including grounds can cleaned was well, Personally I would not replace it. For example, if the gas tank gauge is not working cleaning it at the Cluster my fix it if not try cleaning the other end(sending unit).
 
Back
Top Bottom