electrical ? help ...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 14, 2006
Threads
123
Messages
1,108
Location
Central Cali
i have a 77 fj40 and it has decided to start blowing headlight fuses, the 20amp ones, i cant seem to figure out whats going on. can someone please help ? whats wierd is i jumped in this morning 5am and drove for an hour with no problems, when i slowed to turn into a gas station, headlights went out ? i checked the fuse and it was blown. i replaced it and when i pulled the switch it blew again ? the only thing i have done that has me thinking it something other than a switch or ? i added a tach to my cruiser and i tied the light for the tach to the headlight switch, so the tach light would come on when i turned headlights on. could this little tach light draw enough power to make my headlight fuse blow several times ?

any help is greatly apprieciated ...


thanks in advance ... :cheers:
 
i tied the light for the tach to the headlight switch, so the tach light would come on when i turned headlights on. could this little tach light draw enough power to make my headlight fuse blow several times ?

It shouldn't, but there may be a short somewhere. How'd you connect the tach light? Try disconnecting it for a while.

You could poke around with a multimeter, but if it's intermittent, you might not find it that way. Any circuit that's less than 0.6 ohms will blow a 20 amp fuse @12v.
 
pull your fuse panel and clean up ALL the connections- front and back. Reinstall with a liberal application of dielectric grease.

I was blowing headlight fuses at one point and this has fixed my problem for the last 2 years.
 
I added a tach to my cruiser and I tied the light for the tach to the headlight switch, so the tach light would come on when I turned headlights on. could this little tach light draw enough power to make my headlight fuse blow several times ?

any help is greatly apprieciated ...


thanks in advance ... :cheers:


Yes, the new wire could cause the fuse to blow if it is shorted to ground. Since you have recently fooled with it by adding the wire and you are having problems with the circuit you fooled with, that is the first place to look. Remove the new wire or properly connect and insulate it.
 
Back
Top Bottom