DUI vs OEM dizzy

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 27, 2005
Threads
183
Messages
471
Location
San Jose CA
tried to put a DUI dizzy into my 2F but couldn't get it to go far enough in to engage gears and pump. The OEM slips right in.

Finally removed the O ring on the DUI and it slipped right in. Tried putting the O ring from the OEM on the DUI and couldn't get the thing to slide in far enough.

I didn't want to bang on it, but did push pretty hard.

The shafts of the two measure the same..1 1/16

The O ring slot on the OEM is 28/32, the DUI is 31/32

I'm trying to find a thin selection of O rings that might let me slip it in, but...

Any thoughts on this??
 
I take it, you oiled up that O-ring before trying to install the new dizzy?

When installing a new dizzy on mine, I couldn't get the new one in till I oiled that sucker.
 
While pushing downwards to seat the shaft turn the rotor back and forth until it goes home.
 
Ya gotta oil, grease, spit, shove, and TWIST. I know about these things. Seriously. I've seen a lot of o-rings damaged by pushing straight in.
 
Doesn't matter that it came from a running engine, gear still could have been wrong for the running engine. The easiest way to determine if it has the wrong drive gear on it is to look at the teeth of the drive gear, if it is NOT a Toyota drive gear (probably GM) the teeth will be worn down, I've seen them paper thin. The wrong drive gear wants to push the dizzy up out of the engine, so guys install a stronger hold down clamp, then the cam gear wears down the teeth of the drive gear.
 
Back
Top Bottom