driveshaft work???

[88chevota]

Hey guys I have just found out that I might need a whole new front driveshaft made for the set up I am doing. The rear is going to be fine and tom woods can make a flange for me that will work! the front is the problem because the output shaft is a ten spline. Is there a place locally or can someone shed some more light in the subject for me?

Thanks
Tony

 

[88chevota]

so I found out that I can get a 32 spline shaft from a dodge or ford np205 and swap it directly in. any one know where I can find that?

then I can get the flange that fits and keep my front driveshaft or go with a minitruck rear shaft.

I think I'll be going to the junk yard on Friday!!!

 

[Isotel]

you may get lucky at the Pick and pull and find something.. I can go on Saturday if you want!, i know i saw a couple of t-cases pulled out of trucks already, no clue what they where!

I go to Driveline Service of CS, they are south of downtown
http://maps.google.com/maps?hl=en&c...8821634,-104829550,4788779401161390907&dtab=1
Sometimes it takes a bit to get what you want, but just talk to the guys and tell them what your doing.. you should be fine!