Downey Header? Restoration needed?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 1, 2011
Threads
76
Messages
576
Location
Tempe, Arizona
I removed my Headers to correct a leak at the manifold. I'm not sure but the might be Downey Headers. They are marked 8776-1. Does anyone know how to tell?
There is some corrosion and rusting around the flange manifold port holes. Are they still good or do they need some welding and machining to restore the faces?

Thanks for the advice/help.

Ron Stoddard

Header Pipes.webp



Exhaust Port_Header.webp
 
Not a Downey 3 into 2 into 1 "positive interference" Header, probably a MAF 6 into 1. Someone was sure running lean with that Header. I'm thinking clean, paint with 2,000 degree heat paint (not to be confused with the 1,200 or 1,600 degree "make pretend" heat paint), then when you gasket it, paint all four surfaces (head, header, both sides of the gasket) with "paint-on Copper Coat" (not to be confused with copper colored silicone glue).
 
Last edited:
Not a Downey 3 into 2 into 1 "positive interference" Header, probably a MAF 6 into 1. Someone was sure running lean with that Header. I'm thinking clean, paint with 2,000 degree heat paint (not to be confused with the 1,200 or 1,600 degree "make pretend" heat paint), then when you gasket it, paint all four surfaces (head, header, both sides of the gasket) with "paint-on Copper" Coat (not to be confused with copper colored silicone glue).


Thanks Jim. Surprisingly enough, this header is probably at least 30 years old. Maybe even older. I had it coated with Jet-Hot 24 years ago. They have a lifetime warranty. I'm going to see how good it is! ;) Thanks for your advice.
 
Yep, not sure you can jet hot over existing jet hot though ???


Jim, I just found out the headers are shot. I took them to my exhaust guy and he inspected them and discovered cracks and pin holes where the dual pipes join at the flange. I didn't realize it but they had been repaired before. There was no saving them.

So.... I'm in the market for replacements. Do you have any recommendations? TPI? MAF? JT? I saw something about using a 3E Header but I'm not up to speed on that story. I'm not sure if the SOR headers are worth the $ or how many other complications they introduce.
 
Under the circumstances....sors are worth the money....at least until marks makes more....
Do they require modifications? I don’t have a stock set-up. I just want to be able to bolt the header to my existing tailpipe. Is that going to be possible? Why do they want to sell you some other $150 pipe when you buy their header? Why do they recommend braided brake lines?
 
The headers are a two pc design. Anything is possible depending on your skill set or depth of wallet.
 
The headers are a two pc design. Anything is possible depending on your skill set or depth of wallet.

I guess my question is: for $715 do they sell you what you need to combine the two pieces, or do you have to spend another $150 to combine them?

If that’s the case that’s insane. I’ll pay $280 for the cheap raw headers and have them coated for less than $600. SOR is such a rip most of the times.
 
Back
Top Bottom