Dash reasembly, assistance required.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 12, 2005
Threads
59
Messages
259
Website
www.geocities.com
I have two quick questions,

I was wondering if anyone has had the joyus experience of reassembling the dash and pedals, I am struggling with where to start, and what order to go in as far as the dash electronics, what order to install the pedals and linkage etc...

Thanks again,
 
I haven't put mine back together but I took it apart about a month ago. IIRC the order is like this for reassembly...
1. wire harness
2. dash knobs
3. steering wheel and shaft
4. gas and brake pedel assembly
5. clutch pedel and master assembly
6. gauge cluster
7. Heater and all the other trinkity crap.

I hope this helps?
 
I agree with Cornbread, the wiring harness would be first. Then the parking brake handle ass'y and dash switches. I'd install the steering column after the pedals though, just to have more room to work.
What all has been removed?
 
Not really. My '74 has metal tabs welded to the inside of the cowling. (I covered those tabs w/ heat shrink tubing). They hold the wire looms up close to the sheet metal, underside of the cowling, above & away from the switches, choke & heater control cables, etc. That was why I put the wiring in before anything else. I still haven't put the heater box in yet, I'm waiting until I get the sound system into the dash. It's just easier that way. I'll have a look at your pictures again.
 
I think it is easier to reinstall the wire harness first instead of trying to feed it up and around stuff. Did you tag and number all the wires when you removed them? Makes it real easy to reinstall. The spaces around the steering column and instrument panel are very tight, I just think it's easier if the wires are already there.
 
I didn't tag everything because i needed to install a new wire harness, bought the cruiser for $1700 (CAN) as it was not running - bad wiring - killer deal, but now i have to pay for it...

But I had a look and i can see the place to run it where the wiring will be held away from the other obstructions, will install it first...
 
Last edited:
Tuner,
I am interested on the wiring process that you have. Could you send me a step by step process on how you did it. I've been wanting to rewire myself. Thanks in advance man. :cheers: :cheers: :cheers:
 
Back
Top Bottom