Cylinder Head Gasket

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Mr. Toad

20 Year 15 Year 10 Year
Joined
Feb 7, 2005
Threads
63
Messages
1,643
I'm getting ready to re-install the head on my '75 2F. Should I install the head gasket dry? Last time I did this (in '92) I installed the gasket with a Permatex product, if memory serves. But since then I've heard some say that dry installation is correct. Anyone?
 
Pin_Head said:
Just double check that you don't get it on upside down and cover the oil hole for the valve train. It only goes one way.


WORD
 
nuclearlemon said:
dry and use oem...i know of two cruisers that had failures with fel pro gaskets within 6 months (mine being one of them), that an oem gasket cured.


How about the $OR engine rebuild gasket kit? You have me worried about not using an OEM gasket. I'm not sure of the make of the gasket in the kit. I'll check tomorrow.

Thanks,

John
 
tonkota said:
Yup. I just did this one week ago. It's easy to do. I felt like such a moron!

I guess It's a fairly easy mistake to make. The machinist that rebuilt my engine put it on upside down and he's done hundreds of rebuilds over the years. When I put the new one on I was very careful to get it right. The OEM gasket is a lot more obvious as to the correct orientation. It has a copper ring that encircles the oil passage hole on the block. I would reccomend getting the gasket from Toyota. CDan got mine for me.
 
Back
Top Bottom