I am working on the mini truck to cruiser driveshaft conversion right now as well. SOA and swapped springs, it just so happens that the IFS mini truck front driveshaft fits, lenghtwise like it was made for the rear of my cruiser. Here is my problem I slammed into though. Since I just put new gears in, I had to get a fine spline pinion flange. I went with the universal type for a mini truck, and didn't realize that cruiser and mini truck driveshafts have different bolt spread measurements. So, the non CV end of the driveshaft bolts up to the pinion like it is supposed to. Not so for the transfer case/CV end of the driveshaft. What I am doing is having a t-case end flange slightly modified to accept the mini truck u-joint, swapping the mini truck yoke for the cruiser yoke and it will bolt up. I paid more for the stupid u-joint than the machine work needed for this swap. But cheaper than another custom driveshaft.