Cowl/top vent question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 17, 2006
Threads
500
Messages
3,171
Location
Santa Rosa, CA
So, I was trying to figure out why my cowl/top vent isn't working and discovered that the pull is actually a cable, not a solid pull, that the PO somehow got to attach to the arm. I wanted to make sure that 1966 should have a solid pull and is not cable operated.
 
Little blurry, but on my '67 it's a stiff wire in a sleeve.

1916334
 
That's what I was afraid of. The solid pull must have come soon after. I wonder if I can retrofit the solid pull in? For now, I guess I've got to remove the stiff wire pull and lube it up and see where that gets me. Right now, mine won't move at all.
 
They both have a hole in the arm. It might work to switch it over. It's just so hard to get at here it is.
 
Mine is a 12/71 but uses the arm.
Looks like a different set up than @bb67tlc s.

2/1971 uses this same setup. Not sure when the change occured. LivinginthePast could tell us! That harness looks familiar...🆒
 
2/1971 uses this same setup. Not sure when the change occured. LivinginthePast could tell us! That harness looks familiar...🆒

The harness is a work of art that has risen from the dead. It’s one of my favorite pieces of the build.

I learn something new on this site every time I read it. I was unaware that there were different versions of the cowl vent.
 
I got the pull cable loose and the mechanism itself is frozen, so I'm going to have to pull it. And, after 60 years, the bolts are all frozen.

And, for anyone reading this. you can't switch from cable to solid pull from what I can see. Even if I get a new mechanism, there is no hole for the pull to mount in.

@Coolerman - found your great page on removing yours. How did you get to move again? Mine is totally frozen.
 
Last edited:
Now that I have it almost out (at some point during the V8 swap, a leg of the harness got passed through the mechanism, to either have to cut the mechanism or cut about 8 wires to get it all the way out). No wonder they abandoned this system. I can't see how it would ever reliably work. Between the cable and the sliders themselves, there is so much binding.

So, I"m not sure what to do. I can't have the thing leaking. Maybe I just put the SOR stainless steel cover over it and leave for the future. Or ... but the later model version and figure out how to mount solid pull. Or, dangle a rod down from the unit kind of like the damper control in a fireplace and just reach down and yank or push as appropriate.
 
If you remove the long straight rods from the peices they slide in and then clean the decades of dust and grime off the rods, they’ll likely slide freely. I did this recently for my 67 and used what I think remember was some 600 grit emory cloth and sanded b buffed the rods. It helped tremendously.

Also, when screwing / bolting everything back together, be sure to do so semi loosely and verify it closes and opens freely before tightening everything down so it isn’t at risk of binding. There is a lot of ‘adjustment’ in the whole contraption.
 
So, I finally got it out. I'm going to clean up some wiring while I've got it out. Time to get out the brake cleaner and the scotch pads.

1918700
 
First I ran it through my de-rust tank to get rid of the rust. Then I disassembled it and like was suggested used a Brillo pad to smooth the rods that the nylon sleeves ride on. Next I either powder coated it or spray painted it. Can't remember!
 
Back
Top Bottom