Code 26 at idle

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 6, 2012
Threads
342
Messages
11,022
I have a 94, If I let it idle for a while the check engine light comes on for code 26, when the happens the idle gets a little rough and you can smell the exhaust it's running rich. If I drive it on the road for 10 or 15 minutes it goes away. It will even idle fine for about five minutes or so. But then after that it will all of a sudden idle rough and the check engine light will come back on. Anyone experienced this similar situation?
 
I just went through this. New Oxygen sensors fixed it. I'd recently fixed just about everything else, plugs, wires, fuel filter, fuel pump while fixing other issues. The truck immediately ran a lot better, I'm passing people on hills!!! I drive up one long hill several times a day and it never had enough power to just get up the hill and barely keep the speed up. Now, it's no problem. I also did the PAIR delete which allows putting the sensors in the exhaust manifold and leaving the old sensors in place. That helps because you don't need to get those old rusty ones out.

good luck
 
I just went through this. New Oxygen sensors fixed it. I'd recently fixed just about everything else, plugs, wires, fuel filter, fuel pump while fixing other issues. The truck immediately ran a lot better, I'm passing people on hills!!! I drive up one long hill several times a day and it never had enough power to just get up the hill and barely keep the speed up. Now, it's no problem. I also did the PAIR delete which allows putting the sensors in the exhaust manifold and leaving the old sensors in place. That helps because you don't need to get those old rusty ones out.

good luck
Thanks man. After thinking about it and doing research I think the pair valve is not working well at times and causing my issue. I'll block it off and see what happens.
 
Back
Top Bottom