clutch is giving---???

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 30, 2004
Threads
59
Messages
362
Location
Sacramento, CA
So I was driving home on the freeway for about 20 miniutes, temperature was not hot, it was towards the left line in the middle, and my clutch started going down towards the floor with just the weight of my foot. It gave very easily and now, instead of engaging about halfway between the floor and where it sits free, it engages pretty much right at the floor. But, if I let it release the entire way, it will engage around where it normally does. Whats going on??? I don't think the clutch is slipping because it engages the gears fine, and I don't want to say that it is the cable, but I am not sure. Please help!
 
hows the fluid level in the slave cylinder,, do you get more pressure when you punp it ? i would look there first, may be a slow leak or just low fluid level ?
good luck! just my .02
 
sooooooo, you were riding the clutch pedal down the highway?
the only time your foot is to be on the pedal is when ye be shifting.

and if it's an OEM setup, it'll be a hydraulic clutch linkage.....no cable.
 
i just had the same thing happen to me except i was offroad and mine did that and then just got stuck. when i got home i found out my slave cylinder is shot. all the seals and rubber parts are broken and dont hold presure. i got a new slave cylinder from napa but you cqan also get a rebuild kit if you want to keep the stock one.
 
yeah, I was talking to a few buddies and the general consensus is that its the slave. I was not riding the clutch on the freeway, don't worry, my clutch foot was hanging out getting some fresh air :D. I hopped in to try and start it to see if it was going before work, and the clutch wouldn't even engage at all! So I am guessing (hoping) that it could only be a leak somewhere in the plumbing, and not the slave. It was too dark to check for fluids underneath if it was leaking anything, so I'll check when I get working on it bright and early at the butt crack of dawn
 
I suspect the clutch master or slave is leaking past internal seals. Look closely at slave for brakefluid on the outside or ground and inside the firewall below where the clutch rod goes through. Dimes on dollars, one or both are leaking.
 
i like to re-build both at the same time bucause i have done one and have to do the other with in 1mo and nothing is more of a pain in the a** than doing something twice
 
Do the cylinder rebuild kits actually work well? I saw them but was advised to just go with new cylinders... Same thing happened to me - it was the slave (I went through a bottle of fluid just to get home), and one week after replacing it, my master looks to be leaking :doh:
 
rehone the cylinder for sure... the rebuild kits are fine, but chances are the bore is scored and you'll rip the rebuild to shreds pretty quick

i did 3 rebuilds before i learnt this
 
Back
Top Bottom