Check Engine Light

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 29, 2009
Threads
31
Messages
179
Location
Smyrna, GA
I pulled a trailer around town to take my riding lawn mower to the shop. After roughly 45 minutes of pulling my check engine light came on. Any thoughts?? The temp and oil level are normal and it seemed to run ok. The cruiser has 144,530 miles on it. I'm planning on driving it to Florida on Sunday for vacation with my family so I need to get whatever is going on fixed ASAP.
 
I just let it sit for about an hour and went out to crank it up. It cranked up but seemed to hesitate more than usual. A kind of stutter before cranking.
 
Get the code read at any auto zone or advance auto parts for free. Then report back.
 
Be sure and get the actual code number from them and not there "expert" diagnose of the problem listed in there scanner manual, LOL.
 
UPDATE - I went to autozone this morning and they ran the code.

P0136
Definition BBH02S12

This indicated that it is a faulty O2 sensor.

My question - Do I need to replace this before driving to Florida for a week of vacation? Will it damage anything to wait?

Thanks in advance for your help!
 
Before you do anything, get under there and check the plug and wiring for the O2 sensor...

Make sure it's not cut, corroded or melted...

If you can, check the voltage with a meter and make sure it's up to spec...

If not, replace it...

If it is, reconnect, clear the code and wait to see if it comes back...

You won't hurt anything by making your trip as is, but you may see a drop in mpg's :meh:
 
I'd only replace with OEM. The aftermarket ones don't work very well.

You can get OEM for not much more than aftermarket through CDan.

FWIW, you can drive on a blown O2 sensor, but having the light on is kind of a pita because you don't know if there are any other codes being thrown in the process unless you have a SGII. It shouldn't hurt anything as long as it's only the O2 sensors that are blown. Yes, the mileage will suck. I only got 11-12.5mpg when my O2 sensor was bad.
 
I'm going to go ahead and swap them out with OEM so I will get better mileage and get the light off. Too much of a PITA to worry about other possible codes.
 
I'm going to go ahead and swap them out with OEM so I will get better mileage and get the light off. Too much of a PITA to worry about other possible codes.

That is a good idea. As a heads up, the nuts might be frozen and rusted. I have had little success with penetrating oil, but a propane torch and bolt outs worked wonders at getting the rusted nuts of my pipes. You can buy bolt outs at sears but I just used ones from Harbor freight and they worked just fine.
 
Back
Top Bottom