center arm removal - quick question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 29, 2005
Threads
156
Messages
848
Location
Golden Colorado
I have looked and cant find the answer Im lookin for. I have a 73 FJ40 and Im rebuilding the center arm and I cannot get the guy to come out. I have taken off all bolts and then used some muscle and a hammer and It wont budge. I thought I would ask before I go on. I have a torch will this help? Also if I heat it up and place a jack under there shouldn't it just slide out? Do I have to take the whole thing off and put in vise or should I take it off and bring it to a shop?

Thanks for any help at all!!!
 
So you have unbolted the retaining bolt, taken off the adjustment collar thingie which let the spring come out and you have removed the center arm from the bottom of it corrrect?

Put the center arm back on slightly and turn the wheel..

tap with a hammer

It should come out.
 
X2 needs removal of bottom nut
 
Mace said:
So you have unbolted the retaining bolt, taken off the adjustment collar thingie which let the spring come out and you have removed the center arm from the bottom of it corrrect?

Put the center arm back on slightly and turn the wheel..

tap with a hammer

It should come out.


What do you mean by the center arm? Is that the part right above the bottom bolt and lock nut washer (the big metel hinge that goes to the rest of the steering mecinism)

If so I have not taken this off
 
The middle of the center arm looks like a funnel, the bottom of the funnel sticks through the housing and is splined and threaded. That is what the big metal hinge bolts to.

You need to pull the big nut off the bottom and remove the arm as well.
 
Hit it...
 
X2, you just have to get the force to get past the adhesion of the grease.

BTW, hit it from the bottom :D
 
It turns with the steering, you are missing something..

It can't be that frozen in there..


Take a pic
 
If I understand you correctly, you haven't taken the actual arm off of the bottom of the assembly? This is the kind of triangular shaped arm that attacheds to the steering linkage. You have to remove that before the cone shaped shaft will come out of the top of the housing.

Use a ball joint seperator (pickle fork) to seperate the arm from the shaft. It takes quite a lot of hammering sometimes, it did for mine, but it will come off eventually. Then the shaft should just slide out of the top with almost no effort.

I may have totally misunderstood you, but that is how it sonded to me...

HTH
 
Back
Top Bottom