Cdl lockers

[mainecruiser207]

When I put in low cdl light and abs don't light up when I put front or rear lockers on they blink. I looked at control module on drivers sid and this plug that goes into a pigtail has nothing attached to it. I'm going to be checking switch on transfer case later this week. I also put cdl switch in dash and when I push that nothing happens no lights on dash

 

[Broski]

I guessing it's the indicator switch on the transfer case. A lot times they can be removed and cleaned, the bearing gets stuck from none use.

 

[mainecruiser207]

I guessing it's the indicator switch on the transfer case. A lot times they can be removed and cleaned, the bearing gets stuck from none use.

That was my next check and test has sat for 2 years. Neighbors health went down hill and was to hard for him to get in and I finally talked him into letting me buy it and work on it while I'm paying him off

 

[banjo1981]

You will have to get the CDL light and ABS to light up before the front and rear lockers will stop flashing and actually engage. I had the same problem on my last two FZJ80s. Hope this helps.

As @Broski stated, it’s probably as simple as the CDL sensor switch on the transfer case. You can unclip the CDL sensor/switch plug, use a paper clip or jumper wire while under the truck and test to see if the CDL will light up on the dash.

 

[mainecruiser207]

Was switch on transfer case triple locked now. Hook d up some lights on ggm when ncy mount. 3 Rd step of polishing rapid can rustolium. Gonna wax in mg and surface shield the under side. Cats gone welded bungs to straight pipe into cherry bomber