Catalytic Converter Test Pipe

[ZRotheohv]

I'm looking to get a pair of catalytic converter test pipes for my '94, and my local exhaust shop said they can't make them due to legal reasons. But they did say that if I showed up with measurements and flanges that they'd be able to fab something up. I saw on a couple threads that flanges were available online, but I haven't been able to find any. Does anyone have a link?

Or better yet, has anyone seen a kit for a '94 like this:
FJ60 Catalytic Convertor Test Pipe Kit

Or even better, can anyone on these forums fab up a pair for me?

I'd like to be able to put my factory cats back in... Thanks!

 

[incogrhino]

Why remove and "test" would be my question....

 

[bigredmachine]

you could try and find an old cat and just hollow it out, a big ol wood bit would be best for that, not that i would know or anything.

 

[ZRotheohv]

It looks like even old ones are relatively pricey. Plus, I was hoping to get a little clearance at the same time...

 

[Bama4door]

You could ask the exhaust shop if they have any old cats in their recycling pile you could buy or have...

 

[ZRotheohv]

There aren't very many cruisers here in SD... Or do you mean find one that's close and weld on it?

 

[Bama4door]

@ZRotheohv find one that’s close in length and the same inlet/outlet diameter

 

[ZRotheohv]

Okay I'll see what I can do. I was just hoping there'd be an easy swap in/swap out part like there is for the FJ60. Thanks!

 

[Jgunner]

It’s not hard to just bolt one in that the muffler shop makes.