can't remove warn hubs

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 13, 2005
Threads
8
Messages
72
Location
Tucson AZ
I was going to inspect and regrease the front bearings on my 71 FJ40. But when I unbolt the lockers and try to pull them off, they only come out about 1/8 inch befor hanging up. I looked for a circlip or pin, have tried in both locked and unlocked positions, and tapped around with a mallet all, with no sucess.

Do I just need to yank harder, or is there something I'm missing in the removal process?
 
There should be a clip on the end of the axel shaft holding it all on there.
 
I undid the bolts that attached it to the hub. Do I take off the cap where the rotating knob is? Looks like a half-dozen small allen bolts.
 
azlar said:
I undid the bolts that attached it to the hub. Do I take off the cap where the rotating knob is? Looks like a half-dozen small allen bolts.

Yes - remove the allens, behind the dial there will be either a snap ring on the end of the shaft or a bolt and washer. Remove the snap ring or bolt and the hub will slide off.
 
Yep that did the trick! Many thanks all.

Now I need to find a big socket to get that bearing nut off. Thought I had one but it doesn't fit.

Darn, I need another tool...:D
 
Cornbread said:
I just bought a hub socket from NAPA the other day. It cost like 20 bucks. You may be hard pressed to find a 54mm ( that is the hub nut size) I bought a 2 3/32 that fits perfect. I figure this wont be the only time I'll need one.

54 is for the 76 up with disc brakes; his 71 would take a 50mm.;)
 
How much torque do I need to tighten the nut down? It's kinda chewed up so someone used channel-locks or a pipe wrench in the past. That may get me back on the road this week, but I'd rather get a proper tool.

As 65swb45 mentioned mine is a 50mm, I'm heading down to NAPA in the morning to see what they have.

Is the star washer reusable? I hoped to just lock back the tabs once, then replace it next time I open things up.
 
Back
Top Bottom