Broken drive flange bolt

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Ocho77

SILVER Star
Joined
Jan 18, 2014
Threads
277
Messages
2,404
Location
Alpena, MI
Website
www.op-art.guru
I'm in the process of rebuilding my front axle and one of the bolts in the hub, that the drive flange attaches to, just spins when I attempt to take the nut off. Other than cutting the bolt off to remove the flange, are there any other options?

Also, once I do have the drive flange off, what are my options for replacing? Do I need to purchase a new hub, or can I get a new bolt to press in? Or, can I attach the drive flange with 5 bolts, rather than 6?
 
Is the stud turning, or the nut turning on the stud (much more common). If it's the later, the stud can be unscrewed from the hub and replaced.
 
Is the stud turning, or the nut turning on the stud (much more common). If it's the later, the stud can be unscrewed from the hub and replaced.

Stud turning, I took it out and it was bent about 15 degrees. I'm guessing someone over-torqued it.

Not sure if the inside threads are stripped or not. Do you know if I can replace that with a matching bolt from a local hardware store, or need to get a toyota part?
 
These are higher strength studs. helicoil or time-cert would be ok. anything else wont really work. you cant drill out the flange to a larger size... maybe a used hub?
 
If you're in a pinch I've used a bolt before- grade 8 bolt with the flange head, like a motorcycle bolt. Still use the cone washer & other washer, but if the stud's stripped but the flange threads are still good, a bolt will hold it. I think these are just soft sometimes, I've stripped a few of them, being really careful to tighten correctly.
 
Back
Top Bottom