Broke stud on front diff housing

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 30, 2007
Threads
75
Messages
1,357
Location
Los Angeles, CA
Since the DB got trashed, my thread got lost with it. Long story short yesterday I broke one of the studs on my front diff because I was an idiot and misread the FSM for the torque spec.

Come today I extracted it with an extractor pretty easily. I think it was "Spike" who told me to use an extractor. Thanks for reminding me! :cheers: Came out pretty easily. Didn't need to heat it and didn't need to drop the diff. Local dealer should have the stud for me tomorrow morning. :bounce:

stud.JPG
 
Coolio. :D

Don't forget to ask the dealer parts guy if he can look up the torque spec. I suspect there isn't one, but it would be nice to know.
 
Don't forget to ask the dealer parts guy if he can look up the torque spec. I suspect there isn't one, but it would be nice to know.

Will do and will post back here.
 
why'd you pull the diff? .... doing a gear change or something? ..... i want to go to 4.88's and 315's in the future. wondering if you had someone nearby to do the R&P.
 
Front diff nuts = 18ft/lbs and thread lock isn't a bad idea.
 
Front diff nuts = 18ft/lbs and thread lock isn't a bad idea.

we're looking for the stud install torque, if there is one. Thread got broken up in the recent database failure.
 
why'd you pull the diff? .... doing a gear change or something? ..... i want to go to 4.88's and 315's in the future. wondering if you had someone nearby to do the R&P.

re-geared to 5.29s and put in an ARB locker up front. had 4xdoctor in burbank setup my R&P for me. he's a jeep guy but he knows his stuff and has gotten good reviews.

Four X Doctor Off Road & 4x4 Preparations
 
Thx. Bookmarked for future reference. Having someone local do it is much more appealing than shipping my 3rds. I don't know of any good shops on the westside.
 
Bottom out the stud with red loctite, no real torque. I haven't ever had a problem with studs coming loose only the nuts if they are installed without loctite. I'm sure if you search Pirate someone has gone down this path but I doubt it is necessary.
 
Well part guy didn't know about the torque spec for the stud. I'm having some problems getting the stud in all the way. It's in now and seems solid but based on other studs it seems like I it should go in a few more turns. Any advice on installing the stud?

I tried the double-nut trick and it worked but now the stud seems to be tight enough where it's not working. I'll try again tomorrow night, gave up and called it a night.
 
As long as it's at least 1/2" into the hole I wouldn't worry about it. If you used red Loc Tite as someone suggested, it probably locked. The stuff is wicked, I won't use it unless I have to.
 
That's because it isn't published.

That's what I figured. If you torque a stud down, you are forcing it against either the bottom of the hole or into an area of the hole that's not threaded. Either way, you're gonna deform something.
 
Looks like they come with thread locker from the dealer.
 
Just run it in untill the threads on the stud are bottomed out (use lock-tite as said before). It looks like that thread is probably around 10-12mm? My manual says diff carrier retaining nut spec is 35 ft-lbs.
 
Looks like they come with thread locker from the dealer.

yep, mine came the same way. i didn't add any extra thread locker on it.
 
Back
Top Bottom