Brakes getting stiff

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 18, 2015
Threads
20
Messages
71
Location
St. George, UT
I have a 97 fzj80 and recently when I am going at slow speeds like driving into or backing out of the garage the brakes have been stiffening up. Enough to where I have to push really hard to stop. It hasn't really happened as significantly at higher speeds thankfully but I want to diagnose and repair asap. Is it the brake booster failing or just the check valve. I might add I am in southern Utah in 100 degree temps.
 
Hard, solid pedal is most often the booster. When the valve starts dying it can do it occasionally, then more till it's dead all of the time. When it is doing it, turn the motor off, push the pedal, start the motor, does the pedal suck down or stay hard?
 
It could be either the booster, the check valve or the hose. What is happening is lack of vacuum in or to the booster. It should be easy to eliminate the hose and the check valve with some simple testing.

If you do replace the booster it makes sense to replace the check valve and hose as well.
 
You can go OEM, and pay for it once, or you can go cheap, and not only pay for the parts twice, but you'll also get to pay for the labor twice too!!!
 
I started experiencing the same issue a few weeks ago. I found a slight crack at the end of the vacuum line nearest the manifold. Did not go past the clamp but I replaced the hose anyway. That did not fix it. I pulled the check valve last night. It seems to be fine but I have not examined a new one. Slight sucking pressure or blowing on the valve and it works. It might be a little hard to get the valve moving at low pressure, but without knowing what a new one is like it is tough to compare. At this point, I am going to get a new check valve and try that.

I hate to have to buy a new booster if it is not that.
 
Well mine is doing the same thing, but I am not sure it is the booster, since I have a 6bt it's a complete different animal, it might be just my vacuum pump, off the power steering pump :bang::bang::bang:
 
You can go OEM, and pay for it once, or you can go cheap, and not only pay for the parts twice, but you'll also get to pay for the labor twice too!!!

It only takes a few basic tools and about an hour to change one.
 
Back
Top Bottom