Bored throttle body

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I doubt that boring the T-Body will yield any benefit at all with a NA setup.

You want more power you need to get boosted.

Agreed.
 
Meh. Not going to do you any good unless you have a forced-air system...

Just for laughs a few years ago I (that is to say I had someone else)
bore the TB from a 22RE. No noticeable gains, and boring was a PITA because the tb isn't exactly round; it has a slight ellipse to it, almost undetectable to the eye - not sure if the 80 one does.
 
Well, I put a 3mm bored TB, from RC Engineering, on my 3.0 V6 4runner and with the headers and exhuast, it had more power. TB was put on months after the headers and exhaust. In fact it would out run my buddies with similarly built Jeeps with the 4.0 (40 more hp and 40 more lbs/ft of torque stock). So it did something. I asked this question a while ago and got the same response. But now bigger MAF's are becoming the rage, so.... Apparently you can put bigger TB's on other engines and notice an improvement, but the 1fze in not one of them. Air in, Air out, hmmmm.

Jack
 
I don't think you can compare a modded MAf with the TB. The MAF is more about a smaller sensor and how much less it obstructs the housing.

Allowing the engine to breath easier is always a good idea in improving performance but at some point the amount of change to get any meaningful gains gets beyond reason.
 
On its own it's tough to say how much if any you'll gain. I did a RC Engineering ported TB on my 3FE as a package of improvements and I noticed a difference. Improvements are almost always best in combination and in combination are often are more than the individual sum of each part. In my case it was an open air intake, ported TB, rebuilt and balance injectors and a custom exhaust from the manifold back.
 
No no Turbo, not yet. I want to do step by step.Right now I’m still enjoying new motor.

I spoke to John (RC Engineering), they can bore it out 3mm and that’s the maximum. It will take about 3-4 days business days for them to do it, price for $249.00.

Just one quick question,

Actually what’s the size stock 1FZ throttle body?
Also can I reuse the throttle body gasket? Well … if not I guess I need to order new one from Dan.
 
No no Turbo, not yet. I want to do step by step.Right now I’m still enjoying new motor.

I spoke to John (RC Engineering), they can bore it out 3mm and that’s the maximum. It will take about 3-4 days business days for them to do it, price for $249.00.

Just one quick question,

Actually what’s the size stock 1FZ throttle body?
Also can I reuse the throttle body gasket? Well … if not I guess I need to order new one from Dan.

On my 3FE I used a stock gasket but trimmed the inside.
 
Back
Top Bottom