BJ70 Project: Horton

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

It looks good.
 
Bent up some sliders for Horton. I need to cap them and add a step in the center area. They will be mounted up this weekend. I will be selling these too.

1.5" OD DOM Tubing
.120 Thickness

They kick out and up ever so gently at the back.

DSCN4746.jpg




DSCN4747.jpg
 
Last edited:
I'm interested to see what you come up with as far as tubing goes. :D
 
Orange crate came over and we worked on the LJ and the BJ some more. Front bumper is on hold for today while I mounted my sliders and worked on OC's front and rear bumpers.

Mounting the slider to the frame

DSCN4783.jpg



OC adding the legs that attach to the frame

DSCN4784.jpg



Making them stick


DSCN4787.jpg



Installed.


DSCN4793.jpg
 
1001 uses for a tranny jack. Looks great. Couldn't make it yesterday too much junk going on!
 
Bull I will have to take a drive down to Seattle and see if you or we can come up with a design for the middys HZJ73s and BJ74s. Could be a fair market just a couple hours north. Anyways the sliders look super sturdy and really good . I wish I had the time to do some . Thanks for the post (it is one of the best I have seen in 70series tech in a long time)
 
Bull I will have to take a drive down to Seattle and see if you or we can come up with a design for the middys HZJ73s and BJ74s. Could be a fair market just a couple hours north. Anyways the sliders look super sturdy and really good . I wish I had the time to do some . Thanks for the post (it is one of the best I have seen in 70series tech in a long time)

Come on down. It would take about a day to come up with a design and get them on the rig.


Thanks for the props..:grinpimp:



Adding some tube to my base bumper

DSCN4798.jpg





Tacked in place driverside

DSCN4801.jpg




Pass side

DSCN4802.jpg
 
Back
Top Bottom