Birf Help needed!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 27, 2015
Threads
18
Messages
416
Location
Angier, North Carolina
I was wondering if anyone was around Thornton, CO that might be able to lend a quick helping hand ASAP.
I can't seem to get my short side axle for the life of me into my birf while using the hose clamp trick to clamp down the ring..and I'm not sure if ive messed something up.

First time ever messing with a solid axle and could use some guidance. :/

Thanks -Dwight.
 
Try a zip tie. Worked fined for me. Grease the shaft before insertion (I'm serious...this time). Cut off zip tie.
 
image.webp
image.webp
image.webp
image.webp
image.webp
I'll try the zip tie before getting on the axle with my welder. Its flux core so idk how great of an idea it'd be to weld near the splines even with minimal slag thrown.

But I think I may have
re-installed the cage/star upside down..also I think the cir-clip cause the axle ends to get buggered up..hoping I'll be able to smooth em out with a needle file.

How messed up do these look to you guys??
Again thanks for the help/info
 
Try a zip tie. Worked fined for me. Grease the shaft before insertion (I'm serious...this time). Cut off zip tie.

That's all I did. Still had a kid though. Turns out I didn't have the zip-tie tight enough. Now I know.
 
I put some together the other night. Zip tie method doesn't work for me for whatever reason. I just use a flat head screwdriver like the manual says and tap the other end of the shaft with a dead blow hammer. There is aways cussing and frustration whenever I put them together especially putting together the long side.
 
Last edited:
View attachment 1233299 View attachment 1233298 View attachment 1233295 View attachment 1233294 View attachment 1233296 I'll try the zip tie before getting on the axle with my welder. Its flux core so idk how great of an idea it'd be to weld near the splines even with minimal slag thrown.

But I think I may have
re-installed the cage/star upside down..also I think the cir-clip cause the axle ends to get buggered up..hoping I'll be able to smooth em out with a needle file.

How messed up do these look to you guys??
Again thanks for the help/info

Don't feel bad. I tried to do the same thing the 1st time
The Hexagon Piece has a radius machined on the edge, on one side, and not the other.
Of course you learn this after you have joint full of grease.

Someone needs to make a picture book for joint rebuild/assembly (picture books cross language barriers).
 
I had a little trouble putting mine back together also. I used the screw clamp method and it worked for me. The correct assembly of the star/cage caused me some concern initially, but I finally figured it out. Good luck.
 
Hornd; that radius you mentioned would be what looks like a groove on one side but not the other right? And if so that 'grooved' side needs to be facing down into the cup?
 
Not meaning to answer a question you asked Hornd, but yes. The snap ring groove goes on the inside, that's what the snap ring on the axle shaft snaps into. The beveled machined portion goes on the outside, allowing the snap ring to be compressed for axle insertion. I installed mine backwards the first time.
 
First one I did, I had a heck of a time with the zip tie route, finally tried hose clamp and it worked better. Still had a tough time after due to being afraid of damaging it. But in the end I really put a nice dent/hole in the plywood I was banging it down on before it just popped down in it. That grease popping out the bearings was satisfying.
 
Back
Top Bottom