Birf Help Needed in Utah

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 14, 2007
Threads
7
Messages
35
Location
Utah
I just purchase another 96 Cruiser the other day. The front axle needs to be overhauled and I may need some help on this one. I have all my own tools and some mechanical experience but this seems like a lot of work. Is there anyone in Utah able to help with this? I am located in Provo.
 
There are a few of us here in UT...I'm just over in PG, but I wouldn't be able to help... Good luck searching!
 
Yeah I may just end up running it over to Six States and have them do it if I can't get any help.
 
Have you ever done one before? What exactly are you planning to do? New seals and bearings? I'd be able to assist if you were closer...ever up in SLC area? I've got room to work on trucks, just don't have a floor jack nor any stands at the moment...

It's a bit tedious, but really not that bad of a job. Do you have the FSM? It should have all the info you need in it. If not, I think there's a howto online here somewhere regarding front axle rebuild/refresh. Lemme see if I can find it....

Plus, you have a bunch of guys stationed at their compies here pretty much 24/7 so if you run into any issues, you just jump on line and post up.

-Ferg-
 
Get on the Wasatch Cruisers forum, maybe someone there can lend a hand. If nothing else, print off the FAQ on it and dig in. You can post here for help and post on WC if you run into a snag that needs in person help.
 
Do you have all the replacement parts you need? If not, you can get the kit (including trunion bearings/races) from Kurt at CruiserOutfitters.com. He's located in Sandy.

Too bad you weren't 3 weeks earlier, we could have had a birf party. It's really not that bad of a job, just time consuming and messy (read: buy a case of shop towels from Costco), but not difficult. The FSM is also very helpful, especially for putting it all back together and for torque specs. There is also a very good FAQ here on MUD that provides step-by-step instructions with pics.

Not sure when you were planning on doing this, but make sure you have all the parts ready before you dig into it - including parts solvent. If you run into trouble and need a second set of hands, I'm in Highland and could possibly drive down to help you out. I'm also available via phone if needed (eight oh one, 361, nineteen 32)

Good Luck!
 
Back
Top Bottom