Aux fuel options

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I have the same tank on another 80 and was thinking about putting in my CampTeq 80. Im concern because it hangs down below the frame. Have you ever hit it or seen it as limiting?
Doesn't really hang much lower than other components, however I am planning on fabbing up a 1/4 plate to protect the corners.
 
hey guys,

Have spent the last few days reading and rereading threads on aux fuel options. Home made, OEM, blended projects.

My question is I would like to have some OEM parts but can't seem to find a pre built kit. All the links I found to kits are dead or so old they don't apply anymore. Does anyone make a prebuilt kit anymore? If it where is the best place to source parts, especially dual neck filler, transfer pump and switch.

I feel pretty good about installing at this point... just time to source parts.

Thanks,

Tommy
Just a thought on aux tank vs bigger replacement tank...

Big tank gets a hole in it, you're done.
Two tanks means it takes two holes to stop you.

Depending on how you plumb, transfer and monitor, of course.
 
Doesn't really hang much lower than other components, however I am planning on fabbing up a 1/4 plate to protect the corners.

Mine is 2" lower than the frame:( and was installed in 1997 not sure if it has had design changes since. Based on the existing scraps on the underside of my CampTeq 80 the Man-a-Fre tank would get damaged:(. I already have a Aussie 15 gal sub so the Man-a -fre would nice but....
 
Thanks for the write up. Looks like a pain. How close to the DS was it all said and done? Got a few pics?
I'll snap some pics after work today, tomorrow at the latest. The DS has about an inch lateral clearance at the rear corner of the tank, and is at about the bottom edge. If the rear is flexed down at all, that clearance increases is it drops under the level of the tank - I haven't worked out all the geometry yet, but I'm pretty sure the tank wouldn't interfere regardless of the positioning of the rear axle, since you wouldn't expect a lot of lateral movement at the point the two are close even with the right wheel packed and the left dropped. I should mention I'm running 33" inch tires and have the OME 2.5" lift kit installed with 863's or 864's in the rear (don't recall which, but I'll look and confirm).
 
I will post pics here also just for other members reference. Mine has a gap as well on the first strap near the front which can be fixed by just shortening the strap and remounting, but for now I pushed in a rubber isolator to remedy the gap for now. I also welded on a plate to protect the front corner.

20170602_083604.webp


20170602_083715.webp


20170602_083717.webp


20170602_083720.webp


20170602_083842.webp
 
Wow that is snug...

I will be crawling with mine and right now this is the way I am leaning. Concerned that an impact, hard drop or even an unseen bump could cause movement which would contact.
 
Back
Top Bottom