Aussie locker install

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Trollhole

THC
Supporting Vendor
Moderator
Joined
Mar 6, 2005
Threads
1,565
Messages
21,212
Location
Mauldin, SC
Website
forum.ih8mud.com
I'm installing one of these this weekend and need some advice. The Aussie people say I need to have new thrust washers. The engineer also told me about replacing some sort of shaft while I was in there said some of them are like (butter?) and that I ought to scratch it with a piece of sand paper to see if it scratches and if so to replace it. I didn't get the name of the part since he called at 9 last night and I had a few to many by that time. Anybody have any idea what he was talking about and does anyone know where I get these parts and get them overnighted?

Help :confused:
 
Cdan out here can get what you need, if he cannot, there probably are other vendors that can....


The 'cross-shaft' or spider pinion shaft is what the tech guy was talking about.



There are multiple write ups out here on this very topic.....




Good luck!



-Steve
 
I'd be surprised if you needed to replace the crosspin, but the thrust washers are common...cruiserdan on the forum outta have them in stock at a good price, his banner rotates thru every so often, or check his sticki thread in the vendor corner.
 
Trollhole said:
The Aussie people say I need to have new thrust washers.
I have a suspicion that they are now recommending replacment as a matter of course. Many diffs that old would be worn, and their locker doesn't work right if the thrust washers are too worn. (People here have found that out.) The instructions, when you see them, will tell you how to determine if you need new thrust washers or not. Couldn't hurt to have new ones on hand, though. Cheap insurance.
 
I saw very little wear on my cross pin so I slapped it back in. I measured my tolerances with the original thrust washers in and found that it was acceptable but in the upper end of the threshold. I wanted to be in the lower end so I repliced mine and it works great!
 
Yeah, the thrust washers should probably be replaced as a matter of course on our old diffs....but the measurement of the gap between the two halves of the couplers is the acid test. They do give you a range to work in. With .080" thrust washers, I was right in the middle of the range:) Still getting used to the clicking, but I am loving the traction!! Cheers!
 
Back
Top Bottom