So in October I received a brand-new OEM antenna. It worked great! Until last weekend when I went wheeling in north Georgia. The antenna snapped off right at the base. Today while trying to determine what I could do with it I removed the antenna mast section and the plastic piece of weedeater looking stuff that makes the intent to go up snapped off at the very end.
Plastic piece still goes in and out as if it is trying to raise and lower the antenna.
I have an OEM replacement mast but I do not see a way to attach the end of the plastic to the OEM mast.
What is the best thing to do? Part of me is ready to lose the power antenna and go with a really good aftermarket stubby antenna.
Any suggestions on which route to go?
Plastic piece still goes in and out as if it is trying to raise and lower the antenna.
I have an OEM replacement mast but I do not see a way to attach the end of the plastic to the OEM mast.
What is the best thing to do? Part of me is ready to lose the power antenna and go with a really good aftermarket stubby antenna.
Any suggestions on which route to go?