another newbe question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 11, 2005
Threads
13
Messages
38
I was doing what I thought would be a simple rear-main seal replacement when I found the first problem- my bellhousing is broke,from the slave opening to the middle of the top. My second problem is the leak is from the cam plug, no biggie but my local dealer wasn't sure which plugs to order, they claim there are three plugs on the rear of the block, is this true? I ordered all three for a grand total of $7.79-sweet. Now I need to address the bellhousing. I have a three speed now with the f-motor, what I am going to is a 383 and a 4-speed. I have the motor and the adapter, but it needs to be rebuilt. looking at the hayes book the 4-speed behind the f-motor has a 5.299:1 first compared to a 4.925:1 first for the h41, how hard is to find this trans and are there any problems with this combo? I would to put the trans in first while I rebuild the chev 383. Thanks in advance.
 
bump for a newbie
 
Hi All:

I think you are refering to the really old, early 1960s 4 speed transmission that came with the single-speed transfer case. Not really available, and not a good chose behind a 383 stroker V-8!

I'd suggest buying the 4 speed H42 transmission and associated transfer case (aka the "split" t-case) that came in US-market FJ60 wagons (1981-84) and get the bellhousing as well. This will provide a good bellhousing, a good 4 speed tranny, and a very strong t-case (to survive behind that hopped-up SBC!)

Good luck!

Alan
 
Thanks for the bumps and the info. So will a h41 or a h42 holdup to a sbc or should i just swap out to a sm420?I already have a conversion bellhousing for a toyota 4-speed and I think it will work for a sm420 but I was thinking about how long this combo was. I would also would like to use the stock 3-spd transfercase if possible. I have all kinds of chev parts and i have worked on these all my life.My fj and motor have had a very hard life [rust,poor repairs,very heavy snowplow and very low oil pressure @13 psi at idle] that is why i'm going to a sbc. Thanks for the help!
 
Back
Top Bottom