Another 8274 question.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 19, 2005
Threads
203
Messages
4,692
Location
South west utah
My old winch worked fine, but I wanted to get it freshened up. I took it to a shop with the control box still attached and got the control box back so I could paint it. Problem is I don't remember the ground and the hot lead from the battery attach to the winch. I found some wiring diagrams but they don't match the existing wiring in my winch. It worked fine wired the way it is, I just don't know where to hook up power and ground.
20160826_215701.webp
20160826_215653.webp
 
One thing I see is that the green wire in the upper right should be down one stud, i.e., attached to where the other green wire is.

You are working with an H-Bridge. This gets you the bi-directional function for the motor. Turn on the two opposite diagonal relays at a time, either pair, but never all of them.

Big relays like that have an S terminal, and an I terminal. The S is start, and I is Ignition. I was used back in the day to throw full 12V to the coil when starting, thereby bypassing the ballast resistor to the coil. I don't expect you'd use the I terminal.

I don't think it should work wired the way it is. Maybe in one direction only.
 
None of the wires have been moved sense it got taken apart other than the positive from the battery and the ground. And it definitely worked fine before I took it off the rig.
 
I have an old 8274 and the ground wire goes to the back side of the motor (see first pic)
The positive wire from the battery goes to the bottom of the left bottom solinoid see 2nd pic.
.
IMGP2335.webp
IMGP2336.webp
 
That's where I thought the power went. I am just going to hook it up and see if it works still. I wonder if the controler is wired backwards. The remote is so old I can't tell what way is in or out. It definitely worked both ways before I took it off.
 
Back
Top Bottom