For future generations, the magnet switch #1 (under passenger side battery box) @asutherland was able to use was a Cole Hersee 24812, I've recently run into the same issue as him and it will require replacement.
Aisin 80 series factory winch rebuild (1 Viewer)
- Thread starter asutherland
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Ok, this is a really old thread revival but I’m dealing with this as well. I took apart my winch because when I operated it it dumped all the ATF, and now I cleaned it and replaced all the seals (including the O ring on the motor side, the X ring where the drum mounts on the motor shaft, and the small round cap type seal). And yet .. when I operate the winch, oil comes out from the motor side. I did forget to put MP grease anywhere the arrows in the FSM say I must, but that can’t possibly be the cause, can it?
asutherland
VA7 HDT
- Thread starter
- #63
Probably not related to the grease points. If I were guessing I'd say the seal didn't sit properly or got damaged.
I ended up ditching my oem winch after it constantly let me down, usually when I needed it most, and brought a Warn XPS9.5. No regrets.
forum.ih8mud.com
I ended up ditching my oem winch after it constantly let me down, usually when I needed it most, and brought a Warn XPS9.5. No regrets.
Builds - The Dentist - Turbo Diesel LX450
They shipped it UPS and of course UPS ****ed it up. After UPS refused to play nice, Huracan took the hit and refunded Ed and I for the shipment screw-up UPS did. Amazing customer service these guys. Nothing but good things to say about our experience with them. Clearly my wife supports...
forum.ih8mud.com
Last edited:
Hi, was wondering if this FSM was still available? Thanks in advance!
asutherland
VA7 HDT
- Thread starter
- #65
I have it, I'll upload it when I'm at the computer tomorrow
Here you go! (sorry I didn't see the question).
Meanwhile, I rebuilt my winch, redid all the seals, loaded up the ATF and the bastard is leaking from the right side (when facing the car). So infuriating. Same place it leaked from before I took it apart. No idea what to do with it, argh,
Meanwhile, I rebuilt my winch, redid all the seals, loaded up the ATF and the bastard is leaking from the right side (when facing the car). So infuriating. Same place it leaked from before I took it apart. No idea what to do with it, argh,
