air cleaner cfm

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

metalonmetal said:
can anyone school me on cfm? is there any benefit to having an air cleaner that'll flow 395 cfm into a 2f?

Well, you want it to = or better the CFM of the carb....and I think that is about right. You can do a math story problem and figure it out. This sounds like a task for BSevans. And I do not mean any sarcasm by that, he is an engineer.

Ed
 
Be sure not to make the mistake many others make by reaching for better flow at the expense of better filtration. K&N filters (just as an example) flow very well but don't stop as much grit as others do.
 
i'm thinking of not only replacing the filter but the complete air cleaner assembly, with a donaldson medium-dust condition cleaner, and hopefully one of those skookum turbo ii precleaners... basically making a snorkel...
 
By my calculations a 2F engine at 4000 RPM pulls 297 CFM, at 5000 RPM pulls 371 CFM and at 6000 RPM pulls 444 CFM. I would want an air cleaner system that has a greater flow than the maximum RPM I would limit my driving to. Air cleaners are rated under ideal conditions (new filter, low dust). You need to size your system to allow for reduced flow from a dirty filter, dusty conditions and the inherent restrictions to flow from the air filtration inlet circuit. Take for example a snorkel system. At high RPMs the snorkel system, which is made up of straight and curved sections acts to some degree as a restrictor to flow. It is basic thermodynamics. The interaction of Laminar and turbulent flow over a defined path.
 
bsevans said:
By my calculations a 2F engine at 4000 RPM pulls 297 CFM, at 5000 RPM pulls 371 CFM and at 6000 RPM pulls 444 CFM. I would want an air cleaner system that has a greater flow than the maximum RPM I would limit my driving to. Air cleaners are rated under ideal conditions (new filter, low dust). You need to size your system to allow for reduced flow from a dirty filter, dusty conditions and the inherent restrictions to flow from the air filtration inlet circuit. Take for example a snorkel system. At high RPMs the snorkel system, which is made up of straight and curved sections acts to some degree as a restrictor to flow. It is basic thermodynamics. The interaction of Laminar and turbulent flow over a defined path.

See....:D
Ed
 
haha i work with engineers frequently, i feel like i'm at work.
soooo... i never take my tired 2f above 4k rpm... i'll say it's max is 5k rpm. not without a nice rebuild would i dare take it to 6,000. so a 395 cfm flowing air cleaner would be a nice match... thermodynamically speaking... ? or would you look for something with a bit more flow?
 
That air filter's capability does not take into consideration how you supply air to the filter, what the temperature of the incoming air is, the altitude and the moisture content of the air. Are there issues with the size of the next larger air filter housing? Does it have an interference with the hood or MC? I would be inclined to install the size that fits; not only the engine bay but your eye and not let cost be the primary factor. Clearly under all but the most extreme conditions the system you have chosen will most likely do you proud.
 
it is rather large. it's basically a cylinder... 8 or 9" in diameter, 19" long, with a 4.5" inlet and 4" outlet. if i can't fit it under the hood it's gonna have to be mounted on top of one of the fenders.
 
Back
Top Bottom